Comfee Dishwasher — KWH-TD602E-W

1. To fill the salt, open the salt compartment cap. 
2. When filling for the first time, fill the compartment with salt and water until it is almost full. We recommend using a funnel to make filling easier. 
3. Then replace the cap and close. 

Depending on the usage of the dishwasher, you may need to check and refill the salt every 20-30 washes. 

If the dishwasher isn’t draining, try the following: 

• Ensure the filter has been fully removed and cleaned, and the filter housing area has been cleaned. 
• Check that the outlet pipe does not have any kinks or bends that could be restricting the water flow.  
• Check for any blockages in the outlet pipe that could be preventing the water from draining. 
• Try a hot wash to give the internal pipes a good clean. 
• Check for any error codes on-screen and refer to your user manual. 

If the issue is still not resolved, please get in touch with the support team using the contact details on this page. 

If the programme will not start, check the following: 

• Is there water going into the appliance? If not, check the inlet pipe and ensure the tap is fully open. 
• Check if a delay timer has been set. 
• Turn the appliance off, switch off from the plug and unplug. Whilst unplugged hold down the start/pause button for 10 seconds. Before switching back on leave the appliance for around 30 seconds, then switch back on. 
• Check that the door is closing properly. 
• Check for any error codes on-screen and refer to your user manual. 
• Drain the filter out slowly and check for any blockages. Then clean the filter and refit. 
• Check that the outlet pipe does not have any kinks or bends that could be restricting the water flow. 
• Check for any blockages in the outlet pipe that could be preventing the water from draining. 

If the issue is still not resolved, please get in touch with the support team using the contact details on this page. 

If the spray arms aren’t moving, try the following: 

• Remove the spray arms and clean them by soaking in warm water and using an ear bud to clean the holes. 
• Ensure they are connecting correctly. 
• Check that water is entering the appliance by ensuring the inlet pipe is not kinked or blocked. 

If the issue is still not resolved, please get in touch with the support team using the contact details on this page. 

If the tablet dispenser is not opening, try the following: 

• Check the water pressure on the appliance. 

If the issue is still not resolved, please get in touch with the support team by using the contact details on this page.